Toyota Pinion Flange Fit Kit Use When Upgrading to 29 Spline Pinion by Nitro (YOKTOYFITKIT-29)

Replaces Toyota OE Part number 41204-35100 & 41204-35110.

Required to fit Nitro 29 Spline 8” or 9.5” Ring & Pinions to 2002 & older vehicles.


In 2002, Toyota started using 29 Spline pinion & flange on the 8” & 9.5” differentials. Following Toyota's lead for an upgrade, Nitro Gear & Axle has been upgrading much of their line of Ring & Pinions for Toyota to 29 Spline. This means, if you are fitting the newer 29 Spline Ring & pinion to a 2002 or Older diff, you will need this flange.

Differential: Toyota 8" & 9.5"
Pinion Spline Count: 29
Bolt Patterns: 60mm x 60mm, 66mm x 66mm
Seal Surface: 1.615"/41mm
Kit Includes:
  • Dual Drilled Pinion Flange
  • Pinion Nut
  • Pinion Seal
Toyota 8" V6 29 Spline Ring and Pinion NITRO

High performance Nitro Ring & Pinion gear set for Toyota V6 in a 29 Spline

Nitro Ring & pinions are made from the highest quality forgings using state-of-the-art CNC machining processes. Strict tolerences ensure precision fitment and hassle free installation. Computer controlled lapping processes result in an excellent contact pattern and a quiet running setup that will last.

Each new application is test fitted by real differential experts and put through stringent review process prior to being released. Nitro is hard at work developing new products that you demand.  Models w/ factory 3.07 & 4.88's have a different offset and will need a new dropout when changing ratio.

NOTE

 The spline on the Pinion for the flange is 29 Spline, if you have a 27 spline flange you will also need to purchase a 29 Spline Flange with Nut and Seal

If you have a 2001 and Older Toyota Pickup then most likely your pinion flange is going to be 27 Spline. The easiest way to verify this is to count the splines on the pinion gear. If you want to run the  29 Spline Ring and Pinions, you will need a new 29 Spline Flange, Seal and Nut.

High performance Silverback Ring & Pinion gear set for Toyota V6  29 Spline

Silverback Gears are the highest quality ring and pinions available for Toyota and Suzuki Vehicles.  These are made from heat treated 8620 Alloy on USA Gleason Machines. Gleason is the widest known hypoid gear cutting machines on the planet.  Low Range Off Road will not settle for cheap gears. These ring and pinions are known for their quiet running and high strength. They have been beaten, tested and proven on the road daily and off road in the toughest trails across the world.  They are consistent in set-up and have the most consistent wear patterns out of any aftermarket Toyota gear available.  We don't want to be stranded off road using an inferior ring and pinion, why should you? Models w/ factory 3.07 & 4.88's have a different offset and will need a new dropout when changing ratio.

NOTE

 The spline on the Pinion for the flange is 29 Spline, if you have a 27 spline flange you will also need to purchase a 29 Spline Flange with Nut and Seal